Switch on the power, start the motor. Using an oilstone stained
with ordinary lubricants completely polished shaft sleeve, press
evenly oilstone with your thumb when polished,wipe motor shaft
sleeve after polished, stop the motor. The purpose of polished is
to eliminate the impact of original film or nanometer film on the
1. Fix the friction block into the short lever groove of the
testing machine,add ordinary lubricant oil into oil box,
well-installed the lubricating oil box and the length of the lever.
2. Start the motor, firstly, let the motor run.Then at set
intervals (such as 10 seconds), plus the weight on long lever ends
one by one, each weight is equal to the pressure of the friction
pair carrying 100 kg. Record the number of weights, look at change
in ammeter pointer, the pointer increase, power consumption
increase, fuel consumption also increase. Noise increases, continue
to add weight (about 3,4 blocks) until the wheel stops, the machine
locking, quickly turn off the power. Remove the weights, remove the
short lever, observe the depth, area and roughness of grinding
marks on cylindrical grinding block.
3. Choose a different angle on the grinding block to install
leverage. Polish shaft sleeve again,it need to polished flat
because the wear in just experiment .
4. Add our wear-resistant lubricating oil into oil box.
5. Plus the weight on long lever ends one by one, one, two ......
Ordinary oil plus about four, the machine will be locked, but our
wear-resistant lubricants plus more than four, the machine still
operate as usual. Look ammeter pointer, only slightly move a
little. Current × voltage = power consumption, ammeter pointer
changes very little,power saving is fuel saving. Gradually add
weight to 12, the machines also operate as usual
6. Remove the oil box, the machine operate as usual. Nano films do
exist, turn off the machine switch.
7. Put down the grinding block to compare with previous grinding
(The testing machine equipped with our infrared thermometer can
make oil temperature experiment: The steps are: put the grinding
block horizontally, plus three weights on the long pole, heat the
oil to boiling, note the time from the start heating to boiling ,
the longer of the time, the better quality of the oil.)
Every time change the oil must use an oilstone stained with
ordinary lubricants to polish shaft sleeve clean.If not clean, the
machine will shake and accompanied by noise, affect experimental
|Machine body||wear-resistant tester 1 set|
|Oil cup||2 set|
|Power cable||1 piece|
|Grinding block||30 piece|